NEC V300X Projector User Manual


  Open as PDF
of 99
 
19
3. Projecting an Image (Basic Operation)
Note on Startup screen (Menu Language Select screen)
When you first turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select one
ofthe21menulanguages.
Toselectamenulanguage,followthesesteps:
1. Use the , , or button to select one of the 21
languages from the menu.
2. Press the ENTER button to execute the selection.
After this has been done, you can proceed to the menu
operation.
If you want, you can select the menu language later.
(→[LANGUAGE]onpage45 and 56)
NOTE:
• Ifoneofthefollowingthingshappens,theprojectorwillnotturnon.
- If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In this condition the
projector will not turn on to protect the internal system. If this happens, wait for the projector's internal components to cool
down.
- When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.
- IftheSTATUSindicatorlightsorangeaslongasthePOWERbuttonispressed,itmeanstheCONTROLPANELLOCKhasbeen
set.
- Ifthelampfailstolight,andiftheSTATUSindicatorashesonandoffinacycleofsixtimes,waitafullminuteandthenturn
on the power.
• TheprojectorcannotbeturnedoffwiththeON/STANDBYbuttonorthePOWEROFFbuttonwhilethePOWERindicatorisashing
greeninacycleof0.5secondonand0.5secondoff.
• DonotdisconnecttheACpowersupplytotheprojectorfor60secondsimmediatelyafterturningitonanddisplayinganim-
age.
• Immediatelyafterturningontheprojector,screenickermayoccur.Thisisnormal.Wait3to5minutesuntilthelamplightingis
stabilized.
• Ifyouturnontheprojectorimmediatelyafterthelampisturnedofforwhenthetemperatureishigh,thefansrunwithoutdisplay-
ing an image for some time and then the projector will display the image.
 previous next