NEC V300X Projector User Manual


  Open as PDF
of 99
 
42
4. Convenient Features
Invertingtheorderofdisplayingtheimagesforlefteyeandrighteye[L/RINVERT]
This function changes the order of displaying the images for left eye and right eye.
Changethesettingifyouhavedifcultyseeing3Dimages.
• EachtimeyoupressthePICTUREbuttonontheremotecontrol,thefollowingmenuitemswillchange:
[L/RINVERT]→[CONTRAST]→[BRIGHTNESS]→ ...
NOTE:When[OFF]isselectedfor[DLP
®
Link],thisfunctionisnotavailable.
NOTE:
• If3DcontentisplayedbackonyourcomputerandtheperformanceispooritmaybecausedbytheCPUorgraphicschip.Inthis
caseyoumayhavedifcultyseeingthe3Dimagesastheywereintended.Checktoseeifyourcomputermeetstherequirements
providedinyouruser'smanualincludedwithyour3Dcontent.
• TheDLP
®
LinkcompatibleLCDshuttereyeglassesallowyoutoview3Dimagesbyreceivingsynchsignals,whichareincluded
inlefteyeandrighteyeimages,reectedfromthescreen.Dependingonenvironmentsorconditionssuchastheambientbright-
ness,screensizeorviewingdistance,theLCDshuttereyeglassesmayfailtoreceivesynchsignals,causingpoor3Dimages.
• Whenthe3Dmodeisenabled,[3D]willbedisplayedinthe[SOURCE]menu.
• Whenthe3Dmodeisenabled,theKeystonecorrectionrangewillbenarrower.
• Whenthe3Dmodeisenabled,thefollowingsettingsareinvalid.
[WALLCOLOR],[PRESET],[REFERENCE],[COLORTEMPERATURE]
• Refertothe[SOURCE]screenunderthe[INFO.]menuforinformationonwhethertheinputsignalis3Dcompatible.
• Signalsotherthanthoselistedbelowwillbeoutofrangeorwillbedisplayedin2D.
[COMPUTER]/[COMPUTER1/COMPUTER2(V300X/V260X)]
640x480@120Hz,800x600@120Hz,1024x768@120Hz,1280x720@120Hz,640x480@60Hz,800x600@60Hz,1024x768@60Hz,
1280x720@60Hz
[VIDEO/S-VIDEO]
Signalswithverticalfrequencyof60Hz
Troubleshootingonviewing3Dimages
Ifimageswillnotbedisplayedin3Dor3Dimagesappearas2D,checkthefollowingtable.Alsorefertotheuser's
manualaccompaniedwithyour3DcontentorLCDshuttereyeglasses.
Possiblecauses Solutions
• Thecontentyouareplayingbackisnotcompatiblewith3D. • Playbackacontentcompatiblewith3D.
• The3Dmodewasturnedofffortheselectedsource.
• Usetheprojector'smenutoturnon3Dmodefortheselected
source. (→ page 41)
• YouarenotusingourrecommendedLCDshuttereyeglasses.
• UseourrecommendedLCDshuttereyeglasses.(→ page 40)
• IftheshutterofyourDLP®LinkcompatibleLCDshuttereye-
glassescannotsynchronizewiththecurrentlyprojectedsource,
the following are possible causes:
- Your LCD shutter eyeglasses are not switched on. • SwitchonyourLCDshuttereyeglasses.
- The battery in the LCD shutter eyeglasses ran down. • Rechargethebatteryorreplaceit.
- [DLP®Link]wasnotturnedon.
• Usetheprojector'smenutoturnon[DLP®Link].(→ page
41)
- The viewing distance between the viewer and the screen is
too far.
• Moveclosertothescreenuntiltheviewergets3Dimages.
• Orusetheprojector'smenutoselect[NON-INVERT]for[L/R
INVERT].
- There are bright light sources or other projectors near the
viewer.
• Keeplightsourcesorotherprojectorsawayfromtheviewer.
• Donotlooktowardabrightlightsource.
• Orusetheprojector'smenutoselect[NON-INVERT]for[L/R
INVERT].
• Ifyourcomputerisnotsetfor3Dviewing,thefollowingare
possible causes:
- Yourcomputerdoesnotmeettherequirementsfor3Dview-
ing.
• Checktoseeifyourcomputermeetstherequirementsprovided
inyouruser'smanualincludedwithyour3Dcontent.
- Yourcomputerisnotsetfor3Doutput. • Setyourcomputerfor3Doutput.
- The resolution of output signal is out of range. • Selecttheresolutionofoutputsignalsupporting3D.
- The refresh rate of output signal is out of range. • Changetherefreshrateto60Hzor120Hz.
 previous next