Filter
Top Products
Switching Commands
158
ProSafe M4100 and M7100 Managed Switches
set igmp querier
Use this command to enable IGMP Snooping Querier on the system, using Global Config
mode, or on a VLAN. Using this command, you can specify the IP Address that the Snooping
Querier switch should use as the source address while generating periodic queries.
If a VLAN has IGMP Snooping Querier enabled and IGMP Snooping is operationally disabled
on it, IGMP Snooping Querier functionality is disabled on that VLAN. IGMP Snooping
functionality is re-enabled if IGMP Snooping is operational on the VLAN.
Note: The Querier IP Address assigned for a VLAN takes preference over
global configuration.
The IGMP Snooping Querier application supports sending periodic general queries on the
VLAN to solicit membership reports.
Default
Format set igmp querier [<vlan-id>] [address ipv4_address]
Mode
• Global Config
• VLAN Mode
no set igmp querier
Use this command to disable IGMP Snooping Querier on the system. Use the optional
address parameter to reset the querier address to 0.0.0.0.
Format no set igmp querier [<vlan-id>] [address]
Mode
• Global Config
• VLAN Mode
set igmp querier query-interval
Use this command to set the IGMP Querier Query Interval time. It is the amount of time in
seconds that the switch waits before sending another general query.
Default
Format set igmp querier query-interval <1-18000>
Mode
disabled
disabled
Global Config