Filter
Top Products
Quality of Service (QoS) Commands
455
ProSafe M4100 and M7100 Managed Switches
match class-map
This command adds to the specified class definition the set of match conditions defined for
another class. The <refclassname> is the name of an existing DiffServ class whose match
conditions are being referenced by the specified class definition.
Default none
Format match class-map <refclassname>
Mode
Note the following:
• The parameters <refclassname> and <class-map-name> cannot be the same.
• Only one other class might be referenced by a class.
• Any attempts to delete the <refclassname> class while the class is still referenced by any
<class-map-name> fails.
• The combined match criteria of <class-map-name> and <refclassname> must be an
allowed combination based on the class type.
• Any subsequent changes to the <refclassname> class match criteria must maintain this
validity
, or the change attempt fails.
• The total number of class rules formed by the complete reference class chain (including
both predecessor and successor classes) must not exceed a platform-specific maximum.
In some cases, each removal of a refclass rule reduces the maximum number of
available rules in the class definition by one.
no match class-map
This command removes from the specified class definition the set of match conditions
defined for another class.
The <refclassname> is the name of an existing DiffServ class
whose match conditions are being referenced by the specified class definition.
Format no match class-map <refclassname>
Mode
match cos
This command adds to the specified class definition a match condition for the Class of
Service value (the only tag in a single tagged packet or the first or outer 802.1Q tag of a
double VLAN tagged packet). The value might be from 0 to 7.
Default
Format match cos <0-7>
Mode
Class-Map Config
Ipv6-Class-Map Config
Class-Map Config
Ipv6-Class-Map Config
none
Class-Map Config
Ipv6-Class-Map Config