Filter
Top Products
Management Commands
647
ProSafe M4100 and M7100 Managed Switches
Access Commands
Use the commands in this section to close remote connections or to view information about
connections to the system.
disconnect
Use the disconnect command to close HTTP, HTTPS, Telnet, or SSH sessions. Use all
to close all active sessions, or use <session-id> to specify the session ID to close. To
view the possible values for <session-id>, use the show loginsession command.
Format disconnect {<session_id> | all}
Mode
show loginsession
Use this command to display current Telnet and serial port connections to the switch.
Format show loginsession
Mode
ID
User Name
Connection
From
Idle Time
Session Time
Session Type
User Account Commands
This section describes the commands you use to add, manage, and delete system users.
The 7000 series software has two default users: admin and guest. The admin user can view
and configure system settings, and the guest user can view settings.
Note: You cannot delete the admin user. There is only one user allowed
with read/write privileges. You can configure up to five read-only
users on the system.
Privileged EXEC
Privileged EXEC
Term Definition
Login Session ID.
The name the user entered to log on to the system.
IP address of the remote client machine or EIA-232 for the serial port connection.
Time this session has been idle.
Total time this session has been connected.
Shows the type of session, which can be HTTP, HTTPS, telnet, serial, or SSH.