NETGEAR M4100-26-POE Switch User Manual


 
Quality of Service (QoS) Commands
492
ProSafe M4100 and M7100 Managed Switches
no auto-voip oui
This command is to delete already configured OUI.
Format no auto-voip oui <oui-prefix>
Mode
auto-voip vlan
This command is used to configure the global Auto VoIP VLAN id. The VLAN behavior is
depend on the configured auto VoIP mode.
Format auto-voip vlan <vlanid>
Mode
Default
no auto-voip vlan
This command is used to set the auto-voip VLAN to the default 2.
Format no auto-voip vlan
Mode
auto-voip oui-based priority
This command is used to configure the global OUI based auto VoIP priority. If the phone OUI
is matches one of the configured OUI, the priority of traffic from the phone is changed to OUI
priority configured through this command.
Format auto-voip oui-based priority <priority-value>
Mode
Default
no auto-voip oui-based priority
This command is used to set the priority to the default value.
Format no auto-voip oui-based priority <priority-value>
Mode
auto-voip protocol-based {remark | traffic-class}
This command is used to configure the global protocol based auto-VoIP remarking
priority/traffic-class. If the remark priority is configured, the voice data of the session is
remarked with the priority configured through this command.
Global Config
Global Config
None
Global Config
Global Config
Highest available priority
Global Config