Filter
Top Products
Routing Commands
249
ProSafe M4100 and M7100 Managed Switches
Virtual Router Redundancy Protocol Commands
This section describes the commands you use to view and configure Virtual Router
Redundancy Protocol (VRRP) and to view VRRP status information. VRRP helps provide
failover and load balancing when you configure two devices as a VRRP pair.
ip vrrp (Global Config)
Use this command in Global Config mode to enable the administrative mode of VRRP on the
router.
Default
Format ip vrrp
Mode
no ip vrrp
Use this command in Global Config mode to diable the default administrative mode of VRRP
on the router
.
Format no ip vrrp
Mode
ip vrrp (Interface Config)
Use this command in Interface Config mode to create a virtual router associated with the
interface. The parameter <vrid> is the virtual router ID, which has an integer value range
from 1 to 255.
Format ip vrrp <vrid>
Mode
no ip vrrp
Use this command in Interface Config mode to delete the virtual router associated with the
interface.
The virtual Router ID, <vrid>, is an integer value that ranges from 1 to 255.
Format no ip vrrp <vrid>
Mode
none
Global Config
Global Config
Interface Config
Interface Config