Filter
Top Products
Switching Commands
143
ProSafe M4100 and M7100 Managed Switches
no ip arp inspection trust
Use this command to configure an interface as untrusted for Dynamic ARP Inspection.
Format no ip arp inspection trust
Mode
ip arp inspection limit
Use this command to configure the rate limit and burst interval values for an interface.
Configuring none for the limit means that the interface is not rate limited for Dynamic ARP
Inspections.
Note: The user interface will accept a rate limit for a trusted interface, but
the limit will not be enforced unless the interface is configured to be
untrusted.
no ip arp inspection limit
Use this command to set the rate limit and burst interval values for an interface to the default
values of 15 pps and 1 second, respectively
.
Format no ip arp inspection limit
Mode
ip arp inspection filter
Use this command to configure the ARP ACL used to filter invalid ARP packets on a list of
comma-separated VLAN ranges. If the static keyword is given, packets that do not match a
permit statement are dropped without consulting the DHCP snooping bindings.
Default No ARP ACL is configured on a VLAN
Format ip arp inspection filter acl-name vlan vlan-list [static]
Mode
Interface Config
Default 15 pps for rate and 1 second for burst-interval
Format ip arp inspection limit {rate pps [burst interval seconds] | none}
Mode
Interface Config
Interface Config
Global Config