Filter
Top Products
Routing Commands
225
ProSafe M4100 and M7100 Managed Switches
no arp retries
This command configures the default ARP count of maximum request for retries.
Format no arp retries
Mode
arp timeout
This command configures the ARP entry ageout time.
The value for <seconds> is a valid positive integer
, which represents the IP ARP entry
ageout time in seconds. The range for <seconds> is between 15-21600 seconds.
Default
Format arp timeout <15-21600>
Mode
no arp timeout
This command configures the default ARP entry ageout time.
Format no arp timeout
Mode
clear arp-cache
This command causes all ARP entries of type dynamic to be removed from the ARP cache. If
the gateway keyword is specified, the dynamic entries of type gateway are purged as well.
Format clear arp-cache [gateway]
Mode
clear arp-switch
Use this command to clear the contents of the switch’s Address Resolution Protocol (ARP)
table that contains entries learned through the Management port. To observe whether this
command is successful, ping from the remote system to the DUT. Issue the show arp
switch command to see the ARP entries. Then issue the clear arp-switch command
and check the show arp switch entries. There will be no more arp entries.
Format clear arp-switch
Mode
Global Config
1200
Global Config
Global Config
Privileged EXEC
Privileged EXEC