Filter
Top Products
Utility Commands
544
ProSafe M4100 and M7100 Managed Switches
clear logging email statistics
This command resets the email alerting statistics.
Format clear logging email statistics
Mode
mail-server
Use this command to configure the SMTP server to which the switch sends email alert
messages and change the mode to Mail Server Configuration mode. The server address can
be in the IPv4, IPv6, or DNS name format.
Format mail-server {ip-address | ipv6-address | hostname}
Mode
no mail-server
Use this command to remove the specified SMTP server from the configuration.
Format no mail-server {ip-address | ipv6-address | hostname}
Mode
security
Use this command to set the email alerting security protocol by enabling the switch to use
TLS authentication with the SMTP Server. If the TLS mode is enabled on the switch but the
SMTP server does not support TLS mode, no email is sent to the SMTP server.
Default
Format security {tlsv1 | none}
Mode
No of Email Sent
The number of email messages that were sent from the switch since the
counter was cleared.
Time Since Last Email
Sent
The amount of time that has passed since the last email was sent from the
switch.
Privileged EXEC
Global Config
Global Config
none
Mail Server Config
Term Definition