Filter
Top Products
IP Multicast Commands
323
ProSafe M4100 and M7100 Managed Switches
no ip multicast ttl-threshold
This command applies the default <ttlthreshold> to a routing interface.
The
<ttlthreshold> is the TTL threshold which is to be applied to the multicast Data packets
which are to be forwarded from the interface.
Format no ip multicast ttl-threshold
Mode
ip mroute
This command configures an IPv4 Multicast Static Route for a Source.
src-addr is Source IP address of a multicast source or source IP route prefix.
src-mask is Mask associated with the source IP address or source IP route prefix.
rpf-addr is IP address to be used as the RPF address.
The interface associated with this
IP address, thus, is used as the incoming interface for the mroute.
preference is Administrative distance for the mroute. The lower values have better
preference. If the static mroute has the same distance as the other RPF sources, the static
mroute will take precedence. The range is from 0 to 255. The default is 0.
Default
Format ip mroute <src-addr> <src-mask> <rpf-addr> <preference>
Mode
no ip mroute
This command removes the configured IP Multicast Static Route.
Format noip mroute <src-addr>
Mode
show ip mcast
This command displays the system-wide multicast information.
Format show ip mcast
Modes
• Privileged EXEC
• User EXEC
Interface Config
No MRoute is configured on the system
Global Config
Global Config
Term Definition
Admin Mode
The administrative status of multicast. Possible values are enabled or disabled.
Protocol State
The current state of the multicast protocol. Possible values are Operational or
Non-Operational.