Filter
Top Products
Utility Commands
606
ProSafe M4100 and M7100 Managed Switches
no sflow sampler
Use this command to reset the sFlow sampler instance to the default settings.
Format no sflow sampler {<rcvr-indx> | rate <sampling-rate> | maxheadersize
<size>}
Mode
sflow poller
A data source configured to collect counter samples is called a poller. Use this command to
enable a new sFlow poller instance for this data source if <rcvr_idx> is valid.
Format sflow poller {<rcvr-indx> | interval <poll-interval>}
Mode
no sflow poller
Use this command to reset the sFlow poller instance to the default settings.
Format no sflow poller {<rcvr-indx> | interval <poll-interval>}
Mode
Field Description
Receiver Index
The sFlow Receiver for this sFlow sampler to which flow samples are to be sent. A value
of zero (0) means that no receiver is configured, no packets will be sampled. Only active
receivers can be set. If a receiver expires, then all samplers associated with the receiver
will also expire. Possible values are 1-8. The default is 0.
Maxheadersize
The maximum number of bytes that should be copied from the sampler packet. The
range is 20-256. The default is 128. When set to zero (0), all the sampler parameters are
set to their corresponding default value.
Sampling Rate
The statistical sampling rate for packet sampling from this source. A sampling rate of 1
counts all packets. A value of zero (0) disables sampling. A value of N means that out of
N incoming packets, 1 packet will be sampled. The range is 1024-65536 and 0. The
default is 0.
Interface Config
Interface Config
Field Description
Receiver Index
Enter the sFlow Receiver associated with the sampler/poller. A value of zero (0) means
that no receiver is configured. The range is 1-8. The default is 0.
Poll Interval
Enter the sFlow instance polling interval. A poll interval of zero (0) disables counter
sampling. When set to zero (0), all the poller parameters are set to their corresponding
default value. The range is 0-86400. The default is 0. A value of N means once in N
seconds a counter sample is generated.
Interface Config