Filter
Top Products
Management Commands
650
ProSafe M4100 and M7100 Managed Switches
username snmpv3 authentication
Use this command to specify the authentication protocol to be used for the specified user.
The valid authentication protocols are none, md5 or sha. If you specify md5 or sha, the login
password is also used as the snmpv3 authentication password and therefore must be at least
eight characters in length. The <username> is the user name associated with the
authentication protocol. You must enter the <username> in the same case you used when
you added the user. To see the case of the <username>, enter the show users command.
Default
Format username snmpv3 authentication <username> {none | md5 | sha}
Mode
no username snmpv3 authentication
Use this command to set the authentication protocol to be used for the specified user to
none. The <username> is the user name for which the specified authentication protocol is
used.
Format no username snmpv3 authentication <username>
Mode
username snmpv3 encryption
Use this command to specify the encryption protocol used for the specified user. The valid
encryption protocols are des or none.
If you select des, you can specify the required key on the command line. The encryption key
must be 8–64 characters long. If you select the des protocol but do not provide a key, the
user is prompted for the key. When you use the des protocol, the login password is also used
as the snmpv3 encryption password, so it must be a minimum of eight characters. If you
select none, you do not need to provide a key.
The <username> value is the login user name associated with the specified encryption.
You
must enter the <username> in the same case you used when you added the user. To see
the case of the <username>, enter the show users command.
Default
Format username snmpv3 encryption <username> {none | des[key]}
Mode
no authentication
Global Config
Global Config
no encryption
Global Config