Filter
Top Products
IPv6 Commands
367
ProSafe M4100 and M7100 Managed Switches
no ipv6 icmp error-interval
Use the no form of the command to return burst-interval and burst-size to their default
values.
Format no ipv6 icmp error-interval
Mode
show ipv6 brief
Use this command to display the IPv6 status of forwarding mode and IPv6 unicast routing
mode.
Format show ipv6 brief
Mode
IPv6
Forwarding
Mode
IPv6 Unicast
Routing Mode
IPv6 Hop Limit
ICMPv6 Rate
Limit Error
Interval
ICMPv6 Rate
Limit Burst Size
Maximum
Routes
Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 brief
IPv6 Forwarding Mode........................... Enable
IPv6 Unicast Routing Mode...................... Enable
IPv6 Hop Limit................................. 0
ICMPv6 Rate Limit Error Interval............... 1000 msec
ICMPv6 Rate Limit Burst Size................... 100 messages
Maximum Routes................................. 3000
Global Config
Privileged EXEC
Term Definition
Shows whether the IPv6 forwarding mode is enabled.
Shows whether the IPv6 unicast routing mode is enabled.
Shows the unicast hop count used in IPv6 packets originated by the node. For more
information, see ipv6 hop-limit on page 358.
Shows how often the token bucket is initialized with burst-size tokens. For more
information, see ipv6 icmp error
-interval on page 366.
Shows the number of ICMPv6 error messages that can be sent during one burst-interval.
For more information, see ipv6 icmp error-interval on page 366.
Shows the maximum IPv6 route table size.