Filter
Top Products
Switching Commands
101
ProSafe M4100 and M7100 Managed Switches
no storm-control unicast
This command disables unicast storm recovery mode for an interface.
Format no storm-control unicast
Mode
storm-control unicast level
This command configures the unicast storm recovery threshold for an interface as a
percentage of link speed, and enables unicast storm recovery. If the mode is enabled, unicast
storm recovery is active, and if the rate of unknown L2 unicast (destination lookup failure)
traffic ingressing on an interface increases beyond the configured threshold, the traffic will be
dropped. Therefore, the rate of unknown unicast traffic will be limited to the configured
threshold. This command also enables unicast storm recovery mode for an interface.
Default
Format storm-control unicast level <0-100>
Mode
no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value for an interface
and disables unicast storm recovery
.
Format no storm-control unicast level
Mode
storm-control unicast rate
Use this command to configure the unicast storm recovery threshold for an interface in
packets per second. If the mode is enabled, unicast storm recovery is active, and if the rate of
L2 broadcast traffic ingressing on an interface increases beyond the configured threshold,
the traffic is dropped. Therefore, the rate of unicast traffic is limited to the configured
threshold.
Default
Format storm-control unicast rate <0-14880000>
Mode
Interface Config
5
Interface Config
Interface Config
0
Interface Config