Filter
Top Products
Routing Commands
314
ProSafe M4100 and M7100 Managed Switches
no distribute-list out
This command is used to specify the access list to filter routes received from the source
protocol.
Format no distribute-list <1-199> out {ospf | static | connected}
Mode
ip rip authentication
This command sets the RIP Version 2 Authentication Type and Key for the specified
interface. The value of <type> is either none, simple, or encrypt. The value for
authentication key [key] must be 16 bytes or less. The [key] is composed of standard
displayable, non-control keystrokes from a Standard 101/102-key keyboard. If the value of
<type> is encrypt, a keyid in the range of 0 and 255 must be specified. Unauthenticated
interfaces do not need an authentication key or authentication key ID.
Default
Format ip rip authentication {none | {simple <key>} | {encrypt <key>
<keyid>}}
Mode
no ip rip authentication
This command sets the default RIP Version 2 Authentication Type for an interface.
Format no ip rip authentication
Mode
ip rip receive version
This command configures the interface to allow RIP control packets of the specified
version(s) to be received.
The value for <mode> is one of: rip1 to receive only RIP version 1 formatted packets, rip2
for RIP version 2, both to receive packets from either format, or none to not allow any RIP
control packets to be received.
Default
Format ip rip receive version {rip1 | rip2 | both | none}
Mode
Router RIP Config
none
Interface Config
Interface Config
both
Interface Config