Filter
Top Products
Green Ethernet Commands
739
ProSafe M4100 and M7100 Managed Switches
Note: Executing 'clear green-mode statistics' only clears the EEE
Transmit, Receive LPI event count, LPI duration, and Cumulative
Energy Savings Estimates of the port. Other status parameters
listed in above table will remain unaffected after 'clear green-mode
statistics'.
Example:
The output of 'show green-mode <s/p>' is indicated below.
(switch) #show green-mode 0/25
EEE Admin Mode................................. Enabled
Transmit Idle Time......................... 0
Transmit Wake Time......................... 0
Rx Low Power Idle Event Count.............. 0
Rx Low Power Idle Duration (uSec).......... 0
Tx Low Power Idle Event Count.............. 0
Tx Low Power Idle Duration (uSec).......... 0
Tw_sys_tx (usec)........................... XX
Tw_sys_tx Echo (usec)...................... XX
Tw_sys_rx (usec)........................... XX
Tw_sys_rx Echo (usec)...................... XX
Fallback Tw_sys (usec)..................... XX
Tx DLL enabled............................. Yes
Tx DLL ready............................... Yes
Rx DLL enabled............................. Yes
Rx DLL ready............................... Yes
Tx_dll_ready Data Link Layer ready: This variable indicates that the tx system initialization is
complete and is ready to update/receive LLDPDU containing EEE TLV. This variable
is updated by the local system software.
Rx_dll_enabled Status of the EEE capability negotiation on the local system.
Rx_dll_ready Data Link Layer ready: This variable indicates that the rx system initialization is
complete and is ready to update/receive LLDPDU containing EEE TLV. This variable
is updated by the local system software.
Cumulative Energy
Saving
Estimated Cumulative energy saved on this port in (Watts * hours) due to all green
modes enabled
Time Since Counters
Last Cleared
Time Since Counters Last Cleared (since the time of power up, or after 'clear eee
counters' is executed)
Table 57. Green-Mode status terms
Term Definition