NETGEAR M4100-D10-POE Switch User Manual


 
Switching Commands
99
ProSafe M4100 and M7100 Managed Switches
the traffic is dropped. Therefore, the rate of multicast traffic is limited to the configured
threshold.
Default
Format storm-control multicast rate <0-14880000>
Mode
no storm-control multicast rate
This command sets the multicast storm recovery threshold to the default value for an
interface and disables multicast storm recovery
.
Format no storm-control multicast rate
Mode
storm-control multicast (Global)
This command enables multicast storm recovery mode for all interfaces. If the mode is
enabled, multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on
an interface increases beyond the configured threshold, the traffic will be dropped. Therefore,
the rate of multicast traffic will be limited to the configured threshold.
Default
Format storm-control multicast
Mode
no storm-control multicast
This command disables multicast storm recovery mode for all interfaces.
Format no storm-control multicast
Mode
storm-control multicast level (Global)
This command configures the multicast storm recovery threshold for all interfaces as a
percentage of link speed and enables multicast storm recovery mode. If the mode is enabled,
multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on an
interface increases beyond the configured threshold, the traffic will be dropped. Therefore,
the rate of multicast traffic will be limited to the configured threshold.
Default
Format storm-control multicast level
<0-100>
Mode
0
Interface Config
Interface Config
disabled
Global Config
Global Config
5
Global Config