Filter
Top Products
Utility Commands
564
ProSafe M4100 and M7100 Managed Switches
DHCP Server Commands
This section describes the commands you to configure the DHCP server settings for the
switch. DHCP uses UDP as its transport protocol and supports a number of features that
facilitate in administration address allocations.
ip dhcp pool
This command configures a DHCP address pool name on a DHCP server and enters DHCP
pool configuration mode.
Default
Format ip dhcp pool <name>
Mode
no ip dhcp pool
This command removes the DHCP address pool. The name should be previously configured
pool name.
Format no ip dhcp pool <name>
Mode
client-identifier
This command specifies the unique identifier for a DHCP client. Unique-identifier is a valid
notation in hexadecimal format. In some systems, such as Microsoft DHCP clients, the client
identifier is required instead of hardware addresses. The unique-identifier is a concatenation
of the media type and the MAC address. For example, the Microsoft client identifier for
Ethernet address c819.2488.f177 is 01c8.1924.88f1.77 where 01 represents the Ethernet
media type. For more information, refer to the “Address Resolution Protocol Parameters”
section of RFC 1700, Assigned Numbers for a list of media type codes.
Default
Format client-identifier <uniqueidentifier>
Mode
no client-identifier
This command deletes the client identifier.
Format no client-identifier
Mode
none
Global Config
Global Config
none
DHCP Pool Config
DHCP Pool Config