Filter
Top Products
IPv6 Multicast Commands
434
ProSafe M4100 and M7100 Managed Switches
no ipv6 mld last-member-query-count
Use this command to reset the <last-member-query-count> parameter of the interface
to the default value.
Format no ipv6 mld last-member-query-count
Mode
show ipv6 mld groups
Use this command to display information about multicast groups that MLD reported. The
information is displayed only when MLD is enabled on at least one interface. If MLD was not
enabled on even one interface, there is no group information to be displayed.
Format show ipv6 mld groups {<slot/port> | <group-address>}
Mode
• Privileged EXEC
• User EXEC
Group Address
Interface
Up Time
Expiry Time
The following fields are displayed as a table when <slot/port> is specified.
When <group-address> is specified, the following fields are displayed for each multicast
group and each interface.
Interface
Group Address
Last Reporter
Filter Mode
Version 1 Host
Timer
Group Compat
Mode
Interface Config
Field Description
The address of the multicast group.
Interface through which the multicast group is reachable.
Time elapsed in hours, minutes, and seconds since the multicast group has been known.
Time left in hours, minutes, and seconds before the entry is removed from the MLD
membership table.
Field Description
Interface through which the multicast group is reachable.
The address of the multicast group.
The IP Address of the source of the last membership report received for this multicast
group address on that interface.
The filter mode of the multicast group on this interface. The values it can take are
include and exclude.
The time remaining until the router assumes that there are no longer any MLD version-1
Hosts on the specified interface.
The compatibility mode of the multicast group on this interface. The values it can take are
MLDv1 and MLDv2.