Filter
Top Products
IPv6 Multicast Commands
425
ProSafe M4100 and M7100 Managed Switches
no ipv6 pim (Interface Config)
Use this command to set the administrative mode of PIM on an interface to disabled.
Format no ipv6 pim
Mode
ipv6 pim hello-interval
Use this command to configure the PIM hello interval for the specified router interface. The
hello-interval is specified in seconds and is in the range 10–18000.
Default
Format ipv6 pim hello-interval <10-18000>
Mode
no ipv6 pim hello-interval
Use this command to set the PIM hello interval to the default value.
Format no ipv6 pim hello-interval
Mode
show ipv6 pim
Use this command to display PIM Global Configuration parameters and PIM interface status.
Format show ipv6 pim
Mode
• Privileged EXEC
• User EXEC
Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 pim
Interface Config
30
Interface Config
Interface Config
Term Definition
PIM Mode
Configured mode of PIM protocol
Data Threshold Rate
Rate (in kbps) of SPT Threshold
Register Rate-limit
Rate (in kbps) of Register Threshold
Interface
Valid unit, slot, and port number separated by forward slashes
Interface-Mode
Indicates whether PIM-DM is enabled or disabled on this interface
Operational-Status
The current state of PIM-DM on this interface. Possible values are Operational or
Non-Operational.