Filter
Top Products
Routing Commands
317
ProSafe M4100 and M7100 Managed Switches
show ip rip
This command displays information relevant to the RIP router.
Format show ip rip
Modes
• Privileged EXEC
• User EXEC
RIP Admin
Mode
Split Horizon
Mode
Auto Summary
Mode
Host Routes
Accept Mode
Global Route
Changes
Global queries
Default Metric
Default Route
Advertise
show ip rip interface brief
This command displays general information for each RIP interface. For this command to
display successful results routing must be enabled per interface (that is, ip rip).
Format show ip rip interface brief
Modes
• Privileged EXEC
• User EXEC
Term Definition
Enable or disable.
None, simple or poison reverse.
Enable or disable. If enabled, groups of adjacent routes are summarized into single
entries, in order to reduce the total number of entries
The default is enable.
Enable or disable. If enabled the router accepts host routes. The default is enable.
The number of route changes made to the IP Route Database by RIP. This does not
include the refresh of a route's age.
The number of responses sent to RIP queries from other systems.
The default metric of redistributed routes if one has already been set, or blank if not
configured earlier
. The valid values are 1–15.
The default route.
Term Definition
Interface
Valid slot and port number separated by forward slashes.
IP Address
The IP source address used by the specified RIP interface.
Send Version
The RIP version(s) used when sending updates on the specified interface. The types are
none, RIP-1, RIP-1c, or RIP-2.
Receive Version
The RIP version(s) allowed when receiving updates from the specified interface. The
types are none, RIP-1, RIP-2, or Both