Filter
Top Products
30 • Getting Started
3.1 CPU Installation
The cPCI-6760DK/P5 CPU module supports an Intel BGA2 Low Power
Pentium-III processor at 500MHz with a 100 MHz front side bus (FSB)
frequency.
The CPU on the cPCI-6760DK/P5 series products is soldered on the PCB
(printed circuit board) in the factory. Users do not need to install any CPU
beforehand to get the system started. The heatsink is also pre-mounted in
the factory. We do not suggest users try to remove the heatsink or CPU. It
may cause an un-recoverable system error and the warranty will be void.
M Please do not try to replace the CPU in the field or remove the
heatsink. It will cause board defects and the warranty will be void.
3.2 Memory Installation
The cPCI-6760DK/P5 CPU module supports two PC-100 144-pin SO-DIMM
sockets for a maximum total memory of 512MB with optional ECC support.
The memory type must be 3.3V SDRAM. The memory module can come in
sizes of 32MB, 64MB, 128MB or 256MB PC-100 144-pin SO-DIMM. The
256MB SO-DIMM should be constructed of 16Mx8 SDRAM chips.
The cPCI-6760DK/P5 is delivered with pre-installed 64MB PC-100 144-pin
SO-DIMM. ADLINK’s factory also provides pre-mounting memory service of
other memory size for volume orders of OEM project on request. Please
contact your dealer or ADLINK’s sales representatives.
Note: Ensure that the RAM modules are firmly seated in the SO-DIMM
sockets and that it is not over the height limitation, otherwise the
components maybe damaged when the SBC is inserted into the
chassis.