Filter
Top Products
Getting Started • 33
3.3.2 DB-6760CF Installation for cPCI-6760DK/P5 and CF card
notice
• Mount the DB-6760CF on the cPCI-6760DK/P5’s IDE connector (CN2).
Please be aware that pin 1 on the DB-6760CF should be aligned with
pin 1 of CN2 on the cPCI-6760DK/P5.
• Fix the DB-6760CF & cPCI-6760DK/P5 by screwing three hexagonal
pillars between them. Leave the hole in front of the CF socket
unscrewed.
• Set the CF card as master or slave upon application requirements.
• Insert a CF card into its socket, and then check to see if the CF card is
probably seated
• Mount the third screw on the upper side of the CF card to prevent the CF
card from coming loose during heavy vibration.
Note: The CF card on the CPU board utilize the Secondary EIDE
interface (IDE2), which is also wired to the CompactPCI
connector J5. Users need to pay attention to the master/slave
setting to avoid conflicts between devices. The default jumper
setting on the DB-6760CF is set to master.
3.3.3 Removing the DB-6760CF from the cPCI-6760DK/P5
• Remove the upper screw, which prevents the CF card from coming
loose
• Remove the CF card by pushing the ejector level
• Remove all screws & hexagonal pillars on the DB-6760CF
• Remove the DB-6760CF carefully from the 44-pin IDE connector (CN2)
of the cPCI-6760DK/P5