Filter
Top Products
1
1-17 Setting up PostScript or PCL printing with Windows 98/Me
ES3640e MFP EFI User’s Software Installation Guide - 17
Setting up PostScript or PCL printing with
Windows
98/Me
To set up the Fiery as a PostScript or PCL printer, you must install
the PostScript or PCL printer driver for Windows 98/Me and, for
PostScript, the corresponding printer description file. You must
also configure either a local connection for printing directly or a
network connection for printing over the network.
If you are printing using SMB (Server Message Block), you can
connect to the Fiery and install the printer drivers in a single
procedure. For more information, see “Setting up SMB printing
with Windows 98/Me” on page 1-29.
Note:The procedures for setting up printing with the PostScript
and PCL printer drivers are similar. Either can, and should, be
installed using the Installer program on CD1 supplied with the
ES3640e MFP.
Installing the PostScript or PCL printer driver for
Windows 98/Me
The following procedure describes installing the printer driver
from CD1. Subsequent procedures describe configuring installable
options and setting up the printer connection.
Note:It is strongly recommended that you use the supplied
Drivers CD (CD1) to install the printer drivers. This will
automatically also install the OKI LPR utility, which greatly
simplifies network connection to the printer over a TCP/IP
connection. If you choose to use the standard Windows Add
Printer Wizard, you will need to install this utility from the CD
afterwards if you require these features.
To install the PostScript or PCL printer driver
for Windows 98/Me
1. Insert CD1 into your CD drive and wait for the CD to autorun the setup
program.