Filter
Top Products
65
Unit Installation Section 3-2
Screw-mounting a Repeater Unit
Use M4 × 15 screws to mount the Unit as shown in the following diagram.
Mounting a Repeater Unit on DIN Track
1,2,3... 1. Unlock the DIN Track mounting pins located on the rear of the Repeater
Unit.
2. Attach the Repeater Unit by hooking it onto the DIN Track from above (1)
and then pressing it into place (2).
3. Lock all DIN Track mounting pins.
4. Secure the Repeater Unit by mounting one End Plate on each side of the
Unit. End Plates are attached by hooking first the bottom (1) then the top
of the Plate onto the DIN Track and pulling down (2). Use the screw on the
each End Plate to fasten it in place.
DIN Track
Mount the Repeater Unit to DIN Track. Use at least three screws to attach the
DIN Track to the control panel.
DIN Track: PFP-50N (50 cm), PFP-100N (100 cm), PFP-100N2 (100 cm)
The DIN Track should be attached within the control panel using M4 screws
spaced not more than 210 mm (not more than 6 holes) apart. Attach a DIN
Track in at least 3 points for the longest DIN Track length. Tightening torque
should be 1.2 N·m.
8 mm
81 mm
Two, M4
21 mm
DIN Track mounting pin