Filter
Top Products
69
Wiring Section 3-3
5. Twist firmly the portion of the signal lines that are exposed.
6. Apply vinyl tape or heat-shrinking tube to the end of the cover that was
peeled in step 1.
7. Mount the crimp terminal onto the signal lines and the shield line. Use M3
crimp terminals.
8. Connect the signal lines and the shield line to the terminal block using the
markings on the terminal block.
Note a) You can change the length of the signal lines as shown in the fol-
lowing diagrams to make wiring a lot easier.
Apply vinyl tape or a
heat-shrinking tube.
Shield line
Communications cable
from the previous node
Communications cable
to the next node
Communications data
High signal
Communications data
Low signal
Approx. 30 mm
Approx. 50 mm
Approx. 40 mm