Filter
Top Products
23
Using the Mail Send Function Section 2-4
■ Attached File Name
Send Mail Trigger Type
Setting (Required)
Specifies the type send mail condition that will be used by the Ethernet Unit to
automatically send e-mail.
When the Mail Send Function is not being used, disable the send mail upon
trigger setting.
Note The same trigger type can be set for two or more trigger numbers (1 to 8).
Item Contents Default
Attached file
name
If the above setting is checked so that files can
be sent as attachments, then specify the name
of the file that is to be sent.
None
I/O data file
selected
The data file will be created auto-
matically with the file name
entered in this field.
Note Even if a filename extension
is entered, it will be ignored.
The Unit automatically adds
the appropriate extension
(.IOM, .TXT, or .CSV).
File data file
selected
The file with the specified filename
will be read from the Memory
Card's root directory and attached
to the e-mail.
Note The file must be located in
the Memory Card's root
directory in order to be sent
as an attachment.
Item Contents Default
Software switch If this option is selected, an e-mail is sent when-
ever the Mail Send Switch goes from OFF to
ON.
The Mail Send Switch is bit 03 of word n in the
CIO Area words allocated to the Ethernet Unit
as a CPU Bus Unit. (n = 1500 + 25 × unit num-
ber)
Selected
Word value
change
If this option is selected, the value of a specified
word is compared with a set value with the
selected comparison function (=, <>, <, <=, >=,
or >), and an e-mail is sent whenever the condi-
tion is satisfied.
Specify the desired word address in the drop-
down lists.
Not selected
Bit value change If this option is selected, an e-mail is sent when-
ever the specified bit goes from OFF-to-ON or
ON-to-OFF. Specify the desired bit address in
the drop-down lists.
Not selected
ETN condition If this option is selected, an e-mail is sent when-
ever a new error is stored in the Ethernet Unit's
error log.
Not selected