Filter
Top Products
En-23
Setting the Clock (remote controller only)
1
While the ABX-N300 is in standby mode,
press the [TIMER] button.
If the ABX-N300 is powered-on, press the []
button to enter standby mode.
2
Use the []/[] buttons to select “Clock
Setup.”
3
Press the [ENTER] button.
4
Use the []/[] buttons to set the time, and
press the [ENTER] button.
If you hold down the []/[] buttons, the value
will change continuously.
To switch between 12-hour and 24-hour display,
press the [DISPLAY] button.
5
Use the []/[] buttons to set the “day of the
week.”
6
Press the [ENTER] button.
The setting will be completed, and then the display
will return to the standby condition.
Cancelling without setting the time
Press the [TIMER] button.
Returning to the previous screen
Press the [] button.
Caution
If the power supply is interrupted by a power failure or
by disconnecting the AC adapter, “--:--” will be
displayed, and the clock will stop. If this occurs, set the
clock again.
If you press the [DISPLAY] button while in standby
mode, the clock and day of the week will be shown for
approximately eight seconds.
ENTER
TIMER
F/H
O
DISPLAY
M
Setting the Time and Day of the Week
Timer1 Setup
Timer2 Setup
Clock Setup
Clock Setup
10:15
Sunday
Displaying the Clock