Filter
Top Products
En-27
Network Setup—Continued
Caution
• You’ll use the remote controller to perform these
operations.
• Network settings are made while the ABX-N300 is in
standby mode. If the ABX-N300 is powered-on, press
the [] button to put it in standby mode.
Caution
• When setting up a wireless network connection, you’ll
need to enter the authentication method and security
key. Have these settings ready before you begin.
• Unfold the Wireless LAN antenna located on the back
of the ABX-N300.
1
Disconnect the AC adapter, wait at least ten
seconds, and then reconnect the AC
adapter.
Do not connect the Ethernet cable. If it is
connected, disconnect the Ethernet cable and the
AC adapter, and wait at least ten seconds before
reconnecting only the AC adapter.
2
Press the [MENU] button.
3
Use the []/[] buttons to select “Standby
Mode,” and press the [ENTER] button; then
use the []/[] buttons to select “Network,”
and press the [ENTER] button.
4
Press the [MENU] button.
5
Use the []/[] buttons to select “Network
Setup,” and press the [ENTER] button.
Wait until the “Connection” indication appears.
Are you connecting to the
network by a cable or by a
wireless connection?
Wireless
Cable
Ye s
No
Ye s
No
Ye s
No
Do you have a wireless LAN
router?
Do you have a router, or a modem
that includes router functionality?
See “Connecting via
Wireless LAN” below.
Obtain a wireless LAN
router.
Is DHCP enabled on your
router or router-capable
modem?
Obtain a router.
See “Network
connections (DHCP)” on
page 28.
See “Network
connections (Manual)”
on page 29.
Connecting via Wireless LAN
Network Setup
Network Info
Standby Mode
Beep
Standby Mode
Network
Network Setup
Ethernet
Connection