Filter
Top Products
45
Security Measures
NOTE
Your password will not be displayed on the screen.
Only up to seven alphanumeric characters can be used.
• There is no distinction between upper and lower case letters.
• Use only the upper horizontal row of numeric keys to input your password.
• Do not input your password while holding down on
Shift
or
Ctrl
.
When you do not want the User Password enabled or changed without permission:
A Run the Setup Utility and enter the Supervisor Password.
B Go to [Security] menu. Using
and , select [User Password Protection] and
press
Enter
.
C Using either
or , select [Protected] and press
Enter
.
When [Password on boot] is set to [Enable], it is impossible to start the computer without the
password.
NOTE
You cannot use [Password on boot] without setting the Supervisor Password. Set the
Supervisor Password if you have not done so. ( page 42)
When starting up the Setup Utility, the password input screen will be displayed if a
Supervisor Password or Use Password has been set, even if [Password on boot] is set
to [Disable].
Setting the Password on boot (enabling, disabling)
1 Run the Setup Utility. ( page 88)
2 Using either or , select [Security].
3 Using either or , select [Password on boot] and press
Enter
.
When you do not want your computer to be used without
permission