Filter
Top Products
20
Setting the Supervisor Password
(enabling, changing, disabling)
1
2
Run the Setup Utility ( page 40)
Using and , select [Supervisor Setup], then press
3
Using and , select [Supervisor Password], then press
4
To enable or change your supervisor password
Enter your password at the [Enter Supervisor Password], then press .
CAUTION
Your password will not be displayed on the screen.
Please limit your password to seven characters. Note that there is no dis-
tinction between upper and lower case letters.
White colored keys can be used. Note that the space bar and function keys
cannot be used.
Do not input your password while holding down on or .
Use only the upper horizontal row of numeric keys to input your user pass-
word. The numeric keys combined with alphabet keys on the lower key-
board cannot be used.
Do not forget your password. If a password is forgotten you will be unable
to use your computer.
5
Re-enter your password at the [Enter Supervisor Password
Again]
(This is for confirmation purposes.)
NOTE
Using and , select [Set Supervisor Password], then press
6
At the confirmation screen, press
7
8
Press to end the password setting procedure
9
Close the Setup Utility ( page 40)
When you do not want the User Password enabled, changed, or disabled
without permission,
use and to select [User Password Protection], then set [Enable] with
.
Using and , select [Delete Supervisor Password], then press .
Go to step 7.
To disable your supervisor password
Security Measures