Filter
Top Products
INSTALLING
YOUR MACHINE
25
Installing Your Machine
User Parameters
Setting the User (Internet) Parameters
See Operating Instructions (For Facsimile) if you wish to set the basic settings (User Parameters).
Before starting, you will need a completed copy of page 15 (Pre Installation Information). For your machine to
be able to operate on the Network properly, the following five (5) Basic Parameters must be pre-programmed
into the machine.
• IP Address
• Subnet Mask
• SMTP Server Name or IP Address
• Default Router IP Address
• Email Address
(see Note 1) (see Note 2) (see Note 3) (see Note 4)
Make sure that the Internet lamp is ON. If not, press to select the "INTERNET MODE".
1
2
3
repeatedly until display shows;
4
Enter the IP Address using the keypad. Press or
to enter the period ".". (See Note 4)
Ex:
5
To continue setting other parameters, or press to
return to standby.
NOTE
1. To scroll the display to desired User Parameter in Step 3, press or .
2. The above IP Address fields require an entry to continue. If you wish to erase any of the above IP Addresses
(leave it Blank) and continue to the next step, press , then enter "0.0.0.0" and press . Other
IP Addresses do not require an entry to continue, just press and press to proceed.
3. If the DNS Server is not available, change the setting of the Fax Parameter No. 161 (DNS Server) to "Invalid",
then enter the IP Address instead.
4. For convenience, you can use to enter a period "." while programming IP Addresses only. Otherwise is
used to enter an asterisk in other condition.
SET MODE (1-4)
ENTER NO. OR
∨
∧
1:USER PARAMETERS?
PRESS SET TO SELECT
IP ADDRESS
❚
1 2 3 1 7 8 2 4 0
3
IP ADDRESS
123.178.240.3
❚
STOP
SUBNET MASK
❚
CLEAR
SET
CLEAR
SET