Filter
Top Products
4
A5
A5 R
A4 R
A3
FLS B4
A4
B4·FLS
Operation Chart
Common Features and Usage
■■
■■
■ Basic Operation
NOTE
Original
1
Place the Original(s)
(Up to 70/i-ADF)
2
Press the
COPY Key
3
COPY SIZE
(Reduction/
Enlargement Only)
4
Number
of Copies
5
Press
START
■■
■■
■ Position of the Original
Load Paper
Turn the Power
Switch On
Original Guide
CPlace originals face down on the
platen or face up on the i-ADF.
CIf the original is not positioned
properly, a portion of the original
may not be copied.
CFor originals smaller than A5 size,
position the original within the A5
area and select A5.
■■
■■
■ Commonly Used Functions and Operating Procedures
Full Size
Makes a copy that is the same
size as the original
1452
Reduction or Enlargement
Copies the original at a fixed
reduction or enlargement ratio
13425
CIf the fusing temperature drops excessively on the DP-4510/6010 during a multi-copy
cycle, there is a remote possibility that the copying speed will be reduced. The copying
speed will automatically return to normal when the fusing temperature rises enough to
ensure good fusing performance.
(See page 16)
(See page 18)
Turn the main
Power Switch On
(Located on the
back of the
Copier)
■■
■■
■ Memory Capacity
If the memory becomes full during original scanning, the message “Cannot Complete / Job
Exceeds Memory Capacity” will be displayed on the LCD. If this occurs, follow the instructions
on the LCD.
When additional memory is required, consult with an authorised servicing dealer.
From PlatenFrom i-ADF
Original Guides
Adjust to the original’s width
i-ADF Tray
P004-005_4510(pb).p65 7/31/02, 10:44 AM4