Filter
Top Products
41
NOTE
B4·FLS
Edge/Book/Margin
■■
■■
■ Procedure
Zoom/Effects
∗
Initial setting (Factory setting) can be changed by the function mode.
(See page 62)
∗∗
If a part of the copied image is missing when using the Margin mode,
change the Margin Reduction setting to Yes. (See page 62)
CTo reset each menu mode, touch the CANCEL button on the touch panel.
Edge
#When the vertical and horizontal void areas are the
same, adjust the void width by using the F·G buttons,
then touch the OK button.
#When the vertical and horizontal void areas are
different, select vertical or horizontal edge.
$Adjust each void width by using the F·G buttons.
%Touch the OK button.
∗
Initial setting (Factory setting): 5 mm
#Adjust void width by using the F·G buttons.
$Touch the OK button.
∗
Initial setting (Factory setting): 20 mm
#Select the Margin area.
$Adjust void width by using the F·G buttons.
The image is moved only by the void width which has
been set.**
%Touch the OK button.
∗
Initial setting (Factory setting): 10 mm
Book
Margin
5
Press
START
1
Place the
Original(s)
2
Select ZOOM/
EFFECT Mode
3
Select Edge, Book or
Margin
4
Number
of Copies
Making Copies
P040-041_4510(pb).p65 7/31/02, 10:44 AM41