Filter
Top Products
3. Preparation
24
Volu me
3.5 Adjusting handset
volume
Ringer volume
1. Press {j/OK}.
2. Select “Handset Setup”, then press {>}.
3. Select “Ringer Setup”, then press {>}.
4. Select “Ringer Volume”, then press {>}.
5. Press {e} or {v} repeatedly to select the
desired volume.
6. Press {>}.
7. Press {ih}.
Note:
L Alarms will sound and the handset will ring
for intercom calls and when paged even if the
ringer is turned OFF.
Ring tone
You can select one of 15 ring tones for outside
calls and intercom calls (page 75). Caller ID
service users can also use a different ringer for
each category (page 36).
Receiver volume
While using {C} or {INT}, press {e} or {v}.
Speaker volume
While using {s}, press {e} or {v}.
3.6 Adjusting base unit
volume
Ringer volume
While the unit is idle, press {A} or {B}.
L If any documents are in the document
entrance, you cannot adjust the volume.
Confirm that there are no documents in the
entrance.
To turn the ringer OFF
1. Press {B} repeatedly to display “RINGER
OFF= OK?”.
2. Press {SET}.
L When a call is received, the base unit will not
ring and will display “INCOMING CALL”.
L To turn the ringer back ON, press {A}.
Ring tone
You can select the ring tones from one of 3 tones
for outside calls (feature #17 on page 67).
Speaker volume
While using the speakerphone, press {A} or
{B}.
Answering machine volume
While listening to messages, press {A} or
{B}.
{ih}
{INT}
{j/OK}
{C}
{s}
{>}{e}{v}
{
SET}
{A}{B}
FC235AL-PFQX2248ZA_en.book Page 24 Monday, June 20, 2005 2:19 PM