Filter
Top Products
10. Programmable Features
67
10.2 Basic features
Code #01: Setting the date and time
SET DATE & TIME
PRESS SET
See page 26 for details.
Code #02: Setting your logo
YOUR LOGO
PRESS SET
See page 26 for details.
Code #03: Setting your fax number
YOUR FAX NO.
PRESS SET
See page 28 for details.
Code #04: Printing a sending report
SENDING REPORT
=ERROR [±]
To print a sending report for fax transmission
results (page 49).
“ERROR” (default): A sending report will be
printed only when fax transmission fails.
“ON”: A sending report will be printed after every
transmission.
“OFF”: Sending reports will not be printed.
Code #06: Changing the ring setting in FAX
ONLY mode
FAX RING COUNT
RINGS=2 [±]
To change the number of rings before the unit
answers a call in FAX ONLY mode.
You can select “2” (default), “3”, “4”, “5”, “6”,
“7”, “8” or “9”.
Note:
L Set feature #77 to “FAX ONLY” (page 70)
beforehand.
Code #06: Changing the ring setting in
TAM/FAX mode
TAM RING COUNT
RINGS=2 [±]
To change the number of rings before the unit
answers a call in TAM/FAX mode. You can select
“2” (default), “3”, “4”, “5”, “6”, “7”, “8”, “9”,
“TOLL SAVER” or “RINGER OFF”. See page 55
for details.
Note:
L Set feature #77 to “TAM/FAX” (page 70)
beforehand.
Code #10: Changing the maximum recording
time for incoming messages
RECORDING TIME
=VOX [±]
“VOX” (default): Unlimited.
“1 MIN”–“9 MIN”: 1 minute to 9 minutes.
Code #11: Setting the remote operation ID
REMOTE TAM ID
=ON [±]
1. Press {MENU}.
2. Press {#}, then {1}{1}.
3. Press {A} or {B} repeatedly to select “ON”.
4. Press {SET}.
5. Enter any 3-digit number except a number
using 0 or 7.
L The default ID is “222”.
6. Press {SET}.
7. Press {MENU}.
Code #17: Setting the ring tone for outside
calls
EXT. RINGTONE
=A [±]
To set the base unit ring tone from one of 3 tones
for outside calls. You can select “A” (default),
“B” or “C”.
Note:
L To set the handset ring tone, see page 75.
FC235AL-PFQX2248ZA_en.book Page 67 Monday, June 20, 2005 2:19 PM