Filter
Top Products
97
Remote Operation
Answering
Device
Operating from a remote location
The following operations can be performed from a remote location using a touch tone telephone.
Set the unit to the TAD/FAX mode before going out (see page 89).
Remote command
Stops re-recording of a greeting
message
Erases a specific message
Erases all messages
Changes to the TEL mode
Turns ON message transfer/pager
call for incoming messages
Turns OFF message transfer/pager
call for incoming messages
Remote command
Skips the greeting message
Repeats a message
Skips a message
New message playback
All message playback
Room monitor
Re-records a greeting message
Dial key
7
6
5
4
2
1
0
Page
101
99
99
99
99
100
101
Dial key
82
81
80
5
4
9
Page
101
100
100
101
101
101
Remote operation card
Please cut out and carry this card for assistance when using the remote operation.
1. Call your unit.
2. Enter the remote operation ID
during the greeting
message.
●
The new recorded messages
will be played automatically.
3. Press the remote command
key(s) (see the reverse side)
within 10 seconds.
If there is no new message,
press the remote command
key(s) within 4 seconds.
or
Wait for 4 seconds, and all
the recorded messages will
be played back.
●
The remote operation is
available only from a touch tone
telephone when the unit is in the
TAD/FAX mode.
●
When the unit is in the TEL
mode, call your unit and wait for
15 rings. The answering device
will temporarily answer the line.
Enter the remote operation ID
during the greeting message.
The unit will switch to the
TAD/FAX mode.
●
When you press any key, press
firmly.
●
To send a document, press
. When a fax tone is
heard, start transmission.
9
Answering Device Remote
Operation
Notice of Remote Operation
Fold here