Filter
Top Products
28
Setup
Connections
RJ11C
120 V, 60 Hz
Telephone
line cord
Power cord
Handset cord
Connect to “LINE”.
Power surge
protector
( )
Line surge
protector
( )
Note:
●
The warranty does not cover damage due to power line surges or lightning.
For additional equipment protection, we recommend the use of a surge protector. The following types are
available; TELESPIKE BLOK MODEL TSB (TRIPPE MFG. CO.), SPIKE BLOK MODEL SK6-0 (TRIPPE
MFG. CO.), SUPER MAX (PANAMAX) or MP1 (ITW LINX).
●
When you operate this product, the power outlet should be near the product and easily accessible.
●
If the following message is displayed when the unit is plugged in, the recording paper set lever will be released.
Display:
Move the lever back (see step 3 on page 27).
CHECK LEVER
1
Connect the handset cord.
2
Connect the telephone line cord.
3
Connect the power cord.
●
When the power is turned on for
the first time, the unit will print
some basic information.
Automatic dialing mode setting
●
When the telephone line cord and the power cord are connected, the unit will automatically start to detect the
dialing mode.
Display:
Wait until one of the following messages is displayed.
— If your line has touch tone service:
— If your line has rotary pulse dial service:
●
If the power cord is disconnected or a power failure occurs, the unit will detect the dialing mode again when
power is restored.
●
You can change the dialing mode setting manually. See page 37.
●
If you connect the power cord before connecting the telephone line cord, the following messages will be
shown alternately.
Connect the telephone line cord.
NO TEL LINEINSERT TEL LINE
LINE IS PULSE
LINE IS TONE
CHECKING LINE