Filter
Top Products
9. Programmable Features
52
9.3 Fax features (KX-MB781 only)
Feature/Code Selection
Printing a confirmation report
{#}{4}{0}{1}
{0} “OFF”: Confirmation reports will not be printed.
{1} “ON”: A confirmation report will be printed after every fax transmission.
{2} “ERROR” (default): A confirmation report will be printed only when fax
transmission fails.
Setting the journal report to
print automatically
{#}{4}{0}{2}
{0} “OFF”: The unit will not print a journal report, but will keep a record of the
last 30 fax transmissions and receptions.
{1} “ON” (default): The unit will print a journal report automatically after every
30 new fax transmissions and receptions (page 35).
Sending documents
overseas
{#}{4}{1}{1}
If you cannot send a fax overseas even if the number is correct and the line is
connected, activate this feature before sending the fax.
This feature improves the reliability by reducing the transmission speed.
{0} “OFF”: Deactivates this feature.
{1} “NEXT FAX”: This setting is effective only for the next attempted fax
transmission. After transmission, the unit will return to the previous setting.
{2} “ERROR” (default): When the previous fax transmission fails and you wish to
re-send the document.
Note:
L This feature is not available for broadcast transmission.
L Calling charges may be higher than usual.
Sending a fax at a specific
time
{#}{4}{1}{2}
This feature allows you to take advantage of low-cost calling hours offered by
your telephone company. This feature can be set up to 24 hours in advance of
the desired time.
{0} “OFF” (default)
{1} “ON”
To send a document:
1. If the {FAX} light is OFF, turn it ON by pressing {FAX}.
2. Set the original (page 17).
3. If necessary, change to the desired resolution (page 35) and the desired
contrast (page 35).
4. {MENU} i {#}{4}{1}{2}
5. Press {1} to select “ON”. i {SET}
6. Enter the fax number.
L To enter an item using one-touch dial feature and navigator directory,
see step 3 on “6.3.1 Using the scanner glass”, page 37. (When using
navigator directory, you do not have to press {DIRECTORY} before
pressing {V} or {^}.)
7. {SET}
8. Enter the transmission start time.
L Press {*} repeatedly to select “AM” or “PM”.
9. When using the scanner glass, press {SET}. i {START}
When using the auto document feeder, press {SET}.
L The document will be fed into the unit and scanned into memory. The
unit will then send the data at the specified time.
Note:
L To cancel after programming, press {STOP} while the unit is idle, and then
press {SET}.
MB271-781-PFQX2722ZA-OI-en.book Page 52 Tuesday, May 22, 2007 5:20 PM