Filter
Top Products
8. Programmable Features
69
8.3 Basic features
{#}{0}{0} Setting the Quick Setup
QUICK SETUP
PRESS SET
L Press {SET} 2 times before pressing the
direct command button. See page 21 for
details.
{1} “TAM/FAX” (default)
{2} “DIST. RING”
{3} “TEL ONLY”
{4} “FAX ONLY”
{#}{0}{1} Setting the date and time
SET DATE & TIME
PRESS SET
L Enter the date and time using the dial
keypad. See page 29 for details.
{#}{0}{2} Setting your logo
YOUR LOGO
PRESS SET
L Enter your logo using the dial keypad. See
page 30 for details.
{#}{0}{3} Setting your fax number
YOUR FAX NO.
PRESS SET
L Enter your fax number using the dial keypad.
See page 31 for details.
{#}{0}{4} Printing a confirmation report
CONFIRM REPORT
MODE=ERROR [±]
To print a confirmation report for fax transmission
results (page 48).
{1} “ON”: A confirmation report will be printed
after every transmission.
{2} “OFF”: Confirmation reports will not be
printed.
{3} “ERROR” (default): A confirmation report will
be printed only when fax transmission fails.
{#}{0}{6} Changing the ring setting in FAX
ONLY mode
FAX RING COUNT
RINGS=3 [±]
To change the number of rings before the unit
answers a call in FAX ONLY mode.
{1} “1”
{2} “2”
{3} “3” (default)
{4} “4”
{#}{0}{6} Changing the ring setting in
TAM/FAX mode
TAM RING COUNT
RINGS=2 [±]
To change the number of rings before the unit
answers a call in TAM/FAX mode. See page 53
for details.
{2} “2” (default)
{3} “3”
{4} “4”
{5} “5”
{6} “6”
{7} “7”
{0} “TOLL SAVER”
Note:
L You can also program this feature with the
handset (page 77).
{#}{1}{0} Changing the maximum recording
time for incoming messages
RECORDING TIME
MODE=3 MIN [±]
{1} “1 MIN”: 1 minute
{2} “2 MIN”: 2 minutes
{3} “3 MIN” (default): 3 minutes
{0} “GREETING ONLY”: Only plays the greeting
message.
Note:
L If you select “GREETING ONLY”, the unit will
answer a call with the greeting message, and
then hang up. The unit will not record any
incoming messages.
L You can also program this feature with the
handset (page 77).
{#}{1}{1} Setting the remote operation ID
REMOTE TAM ID
ID=11
1. Press {MENU}.
2. Press {#}, then {1}{1}.
3. Enter a 2-digit number (00–99).
L The default ID is “11”.
4. Press {SET}.
5. Press {MENU}.
Note:
L You can also program this feature with the
handset (page 77).
FPG379-PFQX2138ZA-en.book Page 69 Wednesday, January 12, 2005 4:49 PM