Filter
Top Products
ENGLISH-59
Care and maintenance
+Press the G button and select
the “LAMP RUN TIME” by
pressing the F or G button.
,Press and hold the ENTER
button for approximately 3
seconds.
The “LAMP TIME RESET” will be
displayed.
-Select “OK” by pressing the
I
or
H
button and press the
ENTER button.
This will reset the cumulative
usage time for the lamp unit to
zero. The lamp unit will
automatically shut off, and the
projector will go in the standby
mode.
'Close the air outlet port, and
then use a Phillips screwdriver
to securely tighten the air
outlet port fixing screws.
(Insert the power cord plug into
the wall outlet and then press
the MAIN POWER switch.
)Press the POWER button so
that a picture is projected onto
the screen.
*Press the MENU button to
display the menu screen, and
select “OPTION” by pressing
the
I
or
H
button.
OPTION
OSD
AUTO SEARCH
AUTO SIGNAL
RGB2 SELECT
RGB/YP
B
PR
VGA60/480p
BACK COLOR
CINEMA REALITY
NEXT PAGE @
OFF
OFF
OFF
INPUT
RGB
VGA60
BLUE
OFF
ON
ON
ON
OUTPUT
YP
B
PR
480p
BLACK
ON
SELECT:[^][@]
ADJUST:[{][}] ESC:[MENU]
10 H
OPTION
PREVIOUS PAGE ^
FRONT/REAR
DESK/CEILING
FAN CONTROL
LAMP POWER
LAMP RUN TIME
FUNC1
CONTROL KEY
SET ID
AUTO POWER OFF
FRONT
DESK
STANDARD
LOW
MUTE
OFF
REAR
CEILING
HIGH
HIGH
KEYSTONE
ON
SELECT:[^][@]
ADJUST:[{][}]
ENTER:[ENTER]
ESC:[MENU]
DISABLE
ALL
Power OFF
OK CANCEL
LAMP TIME RESET
NOTE:
BBe sure to install the lamp unit
and the air outlet port securely.
If they are not securely
installed, it may cause the
protection circuit to operate so
that the power cannot be
turned on.
NOTE:
BIf “CANCEL” is selected in step
-, the operation for resetting
the lamp time will be cancelled.
NOTE:
BIf the power indicator on the
projector does not illuminate red
when the MAIN POWER switch
is turned on, turn the MAIN
POWER switch off again and
check that the lamp unit and the
air outlet port are securely
installed. Then turn the MAIN
POWER switch back on.