Filter
Top Products
ENGLISH-63
Others
Covering the connector panel
When installing the projector to the ceiling, the accessory cable cover can be
used to cover the connectors after removing the cut-away parts.
'Tighten the screw by turning it
clockwise.
$Work the cut-away parts back and
forth several times to break the
fixing tabs. Smooth off any jagged
edges if necessary.
#Use pliers or similar to break the
perforated sections of the cut-
away parts.
%Pass the mains lead through cut-
away part S, pass the other
cables through cut-away part L,
and then insert the hook1 of the
cable cover into the mounting
holes in the projector.
&Push in the hook 2 until it locks
into place.
Perforated sections
Hook2
Hook1
Fixing tabs Fixing tabs
Cut-away part S
Screw
Cut-away
part L
Refer to page 62 for details on
removing the cable cover.
NOTE:
BDo not cover the air inlet ports
when using the cable cover as
stated above.
BDo not place any heavy objects
on the cable cover to prevent it
from falling.
BDo not bend the cables greatly,
otherwise it will be difficult to
attach the cable cover.
B
Remove the cable cover when
cleaning or replacing the air filter.