Filter
Top Products
ENGLISH-73
Others
Control commands
The commands which the personal computer can use to control the projector
are shown in the following table.
Command
Control
Contents
Remarks
In standby mode, all commands other than
the PON command are ignored.
BThe PON command is ignored during
lamp ON control.
B
If a PON command is received while the cooling
fan is operating after the lamp has switched off,
the lamp is not turned back on again straight
away, in order to protect the lamp.
Power ONPON
Power OFFPOF
VolumeAVL
Parameter
000-063 (Adjustment value 0-63)
Input signal
selection
IIS
Parameter
VID=VIDEO SVD=S-VIDEO
RG1=RGB1 RG2=RGB2
RG3=RGB3 DVI=DVI
Lamp ON
condition query
Q$S
Callback
0 = Standby
1 = Lamp ON control active
2 = Lamp ON
3 = Lamp OFF control active
Cable specifications
(When connected to a personal computer)
At the projector
At the computer
(DTE specifications)
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
NC
NC
NC
NCNC
NC
NC
NC
OSH Shutter function
Operation will be switched between ON and
OFF each time the command is sent. Do
not switch operation ON and OFF after only
short periods of time.