Filter
Top Products
P300H P300 Series Modem Installation and Operating Handbook Page 100
Remote M&C: 1:Protocol [Paradise]
2:Intfc [RS485] 3:Baud rate[2400] 4:Addr[123]
Change, Rem-M&C, Configure Menu
6.9.2 Change, Rem-M&C, CONFIGURE Menu
This menu configures the remote M&C port: The options are:
PROTOCOL This allows selection between OFF, PARADISE/FDC, and SA-bus. Full details of
the remote M&C protocols and messages is provided in the Remote M&C section
in Appendix D.
NOTE: Remote monitoring is possible with the selected protocol if the protocol
is not set to OFF. Remote control is only possible if the protocol is not Off and
control has been selected as Remote on the Change, Remote M&C menu.
INTERFACE The options available here are RS232 or RS485. RS232 is only usable for a direct
connection between a single device and a PC. RS485 is required when more than
one slave device is connected to the remote M&C bus. Again see the Remote
M&C section for complete details of the electrical interface.
BAUD RATE The remote M&C Baud Rate is selectable, again see the Remote M&C section
for complete details of suitable Baud Rates for each protocol.
ADDRESS The bus address must be specified. The valid range for the Paradise / FDC
protocol is 1-255, for the SA-bus protocol the valid range of address is 49 to 111
(31H to 6FH).