Filter
Top Products
P300H P300 Series Modem Installation and Operating Handbook Page 82
ESC Baud rate: [2400] (YES)
(Max continuous rate is 2962)
Change, Tx/Rx, ESC/Aux/BA, Cfg. Async, Baud Rate Menu
Async Format: [7 bits, No parity]
1=7 bits, 2=8 bits, Parity: 3=None, 4=Even, 5=Odd (Yes)
Change, Tx/Rx, ESC/Aux/BA, Cfg. Async, Format Menu
NOTE: ESC channel not
guaranteed above 2962 Baud (YES)
Change, Tx/Rx, ESC/Aux/BA, Set as Remote Warning Menu
6.6.30 Change, Tx/Rx, ESC/Aux/BA, Config Async, BAUD RATE Menu
This menu allows the Baud rate for the external interface to the ESC channel to be set. Any rate can be set,
although the maximum continuous rate supported is stated (calculated from the terrestrial rate, and async
character format).
Refer to section 8.6 "Determining exact maximum ESC Baud rates" on page 146
6.6.31 Change, Tx/Rx, ESC/Aux/BA, Config Async, FORMAT Menu
The ESC async character format may be edited by pressing 1 or 2 to select 7 or 8 bits, and 3, 4, or 5 to
select No parity, Even parity, or Odd parity respectively. Note that as described in the last paragraphs
shortening the async character reduces the maximum continuous Baud rate, as the ESC channel is limited
to a finite character rate per second, and the more bits in each async character, the higher the effective
Baud rate allowed without exceeding the ESC channel character rate limit.
6.6.32 Change, Tx/Rx, ESC/Aux/BA, Config Async, SET AS REM M&C
This option sets the ESC channel async parameters to match the settings on the Remote M&C port. This
is specifically intended to simplify remote M&C within the IBS/SMS overhead via the ESC channel. Note this
is a `one time` setting, and if the remote M&C parameters are varied, the ESC channel will not follow
them. If the remote M&C Baud rate exceeds the maximum continuous ESC rate, then the following warning
will be issued, although the copying of the parameters will go ahead.