Filter
Top Products
B-1
8000-A2-GB20-50
April 2000
SNMP Traps
B
Traps are configured via a Telnet or terminal session. The addition or removal of
a card or another hardware component within the Hotwire DSL system causes a
trap to be generated. These traps indicate a configuration change notification
(CCN) of a card (a hardware replacement or a software upgrade).
Setting Up SNMP Trap Features
Use the following procedures for setting up SNMP trap features.
DSL SNMP Community Strings and Authentication Failure Trap
"
Procedure
To set up DSL SNMP Community Strings and enable the Authentication Failure
Trap:
1. Follow this menu sequence from the DSL Main Menu:
Configuration →SNMP→Communities/Traps (A-F-C)
2. Enter Read Only community string name(s).
3. Enter Read/Write community string name(s).
4. If desired, enable the Authentication Failure trap.
5. Enter the IP address of addresses of the NMS.