Filter
Top Products
RADSL Card Configuration
3-29
8000-A2-GB20-50
April 2000
Configuring DHCP Relay Agent (dynamic addressing)
Use this procedure to provide dynamic Service Domain IP address allocation to
the end-user systems attached to the DSL RTUs.
" Procedure
To configure relay agent:
1. Make certain that the Next Hop Router address used in relaying DHCP
requests is configured as an e1a address (A-C-B).
2. Select Configuration →DHCP Relay→ Domain Names (A-G-A).
3. Enter the ISP domain names in the Domain Name field, and press Enter after
each entry.
NOTE:
Unless your client supports the domain names field, you will not be able
to have service selection. By default, each port can be assigned one
service provider.
The Interface IP address is read-only and is required to key in the
corresponding domain name.
4. Select Configuration →DHCP Relay→ Servers 1–4, Servers 5–8,
Servers 9–12, or Servers 13–16 (A-G-B, C, D, or E).
5. Enter values for the fields listed in Table 3-7 and press Enter after each entry.