Filter
Top Products
RADSL Card Configuration
3-15
8000-A2-GB20-50
April 2000
DSL Configuration Interfaces Screens
Use the system information submenu of the Interfaces screens to configure basic
interface information.
" Procedure
To configure interface names and MTU settings, IP addresses on the Ethernet
port, PPP settings on the DSL ports, or restart, stop, or monitor an interface:
1. Follow this menu sequence:
Configuration →Interfaces (A-C)
2. The Interfaces menu appears. Enter the desired value on each selected
screen and field as shown in Table 3-3 and press Enter.
Table 3-3. Interfaces Options (1 of 3)
General (Interfaces) A-C-A
Provides the capability of configuring and viewing basic card interface information about
a given interface.
Interface Name – 15 characters. s1b = backplane that connects all the cards;
e1a = ethernet port; s1c, s1d, s1e and s1f = DSL interface. Depending on your selection
in this field, the following prepopulated fields appear:
Type – Static or dynamic.
Protocol – HDLC, PPP, or Ether. For the 8540, the protocol is Ether-HDLC.
Port list – Name of the port associated with this interface.
MTU (max) – 64–64000 (Default = 1500). For the 8540, the MTU (max) is 1500, with
the range being 61–1500.
NOTE: The above MTU values are the only values you may enter. Do not change
the MTU of s1b from the default of 1500. Make certain that if you change
from the default value, the new numbers are appropriate for your network.
Do a card reset or reset the Ethernet interface.