Filter
Top Products
3. Cabling
8620-A2-GN20-40 July 2003
3-3
Connecting a DSL Card Using Cable Ties
Procedure
To connect a DSL card in the 8620 chassis using the provided cable ties:
1. On each cable, replace the longer captive screw on the cable connector with
the #4-40 Phillips pan-head screw shipped in a plastic bag with the unit. Do
not insert the screw past the connector body until Step 4.
2. Plug the Telco 50-pin cable into the appropriate connector for the slot
containing the card (labeled 2 or 3, connector 1 is for future use) on the rear of
the 8620 chassis.
3. Thread the provided cable tie through the anchor mount on the end of the
connector where the cable will lie. Tighten the cable tie around the connector
and cut off any excess.
4. Secure the other end of the Telco 50-pin cable by tightening the Phillips
pan-head screw (that you replaced in Step 1) on the right side of the
connector.
5. Make sure the other end of the cable is connected to the appropriate POTS
splitter shelf, MDF, or demarcation point.
NOTE:
For detailed information about the POTS splitter, refer to the Hotwire Central
Office Universal POTS Splitter, Models 6050 and 7020, Installation
Instructions.
01-16900
Anchor
Mount
Telco 50-Pin
Connector
Cable
Tie
Replaced with
Supplied #4-40
Phillips Pan-head
Screw